absorbed energy

英 [əbˈzɔːbd ˈenədʒi] 美 [əbˈzɔːrbd ˈenərdʒi]

吸收能

机械



双语例句

  1. Some trains carry bicycles, but accommodation is restricted so a reservation is essential.
    有些火车可以运载自行车,但因空间有限需要提前预订。
  2. Detection of Firmness in Peaches by Coefficient of Restitution or Percentage of Absorbed Energy
    利用恢复系数、能量吸收百分率预测桃子硬度
  3. The impact absorbed energy of weld metal is higher under lower weld porosity ratio.
    减少焊缝气孔率可以适当提高焊缝的冲击韧性。
  4. The results showed that absorbed energy, initial angles, maximum acceleration, and restitution coefficient have obvious effect on bruise volume.
    研究表明,吸收能量、跌落角度、峰值加速度、恢复系数对损伤体积的预测较为明显。
  5. Influences of liquids properties and Absorbed energy on laser induced expanding sound
    液体性质与吸收能量对激光致声特性的影响
  6. Immediately, I move my spirit force to let all absorbed energy concentrate on my both hands and mix few own na? Ve qi, using this way I can control the massive world original Qi through few naive qi.
    随即,我调动神念让所有吸取的能量都集中在我的手上,其中再掺入点自己的先天真气,这样一来,我就可以通过少量的先天真气来控制大量的天地元气了。
  7. Problems in Impact Test for Test Temperature and Eligible Parameter of Absorbed Energy
    关于冲击试验的试验温度和冲击吸收功合格指标问题
  8. Difference of impact absorbed energy between butt weld metal and deposited metal
    对接焊缝金属和熔敷金属冲击吸收功差异的探讨
  9. The study was mainly about the influence of the different surface treatment of the laser crystal on the distribution of the absorbed energy, and the surface treatment can restrain the amplified spontaneous emission ( ASE) in the resonator but decrease the laser efficiency.
    重点根据不同表面处理方式的激光晶体对抽运光的吸收情况,分析了晶体表面处理对抑制ASE效应和获得高效率激光输出的影响。
  10. Its absorbed energy efficiency is about 2-3 times of rubber absorber.
    这些吸能器的吸能率为橡胶吸能器的2~3倍。
  11. The technology has selectivity during heating, that is quantity of heat production is in direct proportion to real quantity of water, while absorbed energy depends on the existed quantity of water. Therefore, even drying can be obtained.
    此技术在加热时具有选择性,即产生的热量与实际水量成正比,而吸收的能量取决于存在的水量,因而能够使织物均匀烘干,为下道工序提供最佳处理效果。
  12. The system uses the exchange frequency conversion technical control dynamometer work, provided the load or absorbed energy for the measured engine.
    系统采用交流变频技术控制测功机工作,为被测发动机提供负载,吸收能量。
  13. The absorbed energy property and deformation characteristic of magnesium alloy under high strain rate loading are described.
    介绍了高应变率载荷条件下镁合金的吸能特性及变形特征;
  14. The nonlinear parameter estimation technique can simultaneously estimate the thermal conductivity, heat transfer coefficient and absorbed energy.
    采用非线性参数估计可同时估计出热扩散率、散热系数以及试样吸收的能量。
  15. Through analysis, the phenomenon was thought to have something to do with the absorbed energy of sheet flow on the different slope.
    经分析认为这与不同坡面上水流吸收的能量有关。
  16. Experimental research on dynamic modulus of elasticity and breaking absorbed energy of cement rock by SHPB
    用分段式霍普金森压杆对水泥石动态弹性模量和破碎吸收能的实验研究
  17. When the peak stress is same, the absorbed energy of material under the repeated impact contact load is more than under the static fatigue load. And absorbability is in inverse proportion with the distance from the impact point.
    当峰值应力相同时,材料在多冲接触载荷下比静载荷和静疲劳载荷下吸收的能量多,且吸收量与离冲击点的距离成反比。
  18. The tensile strength, absorbed energy and resilient energy of the composite increase significantly with increasing strain rate.
    拉伸强度、能量吸收和能量回复随应变率增加而显著增加。
  19. Luminescence is a process during which the absorbed energy in some way is converted to optical radiation.
    发光是物体将某种方式吸收的能量转化为光辐射的过程。
  20. The results indicate that the bending load and absorbed energy of partially foam-filled tube significantly increase and the deformation mode changes from single-fold model to multi-fold model when compared with empty tube.
    结果表明:泡沫铝部分填充管承受的弯曲载荷和吸收的能量与铝管相比有显著的提高,弯曲变形模式从空铝管的单褶皱模式转变为多褶皱模式。
  21. The absorption of formation will cause the loss of vertical resolution, it is needed that compensation the absorbed energy by the earth in the data processing.
    地层对地震波的吸收作用会引起垂向分辨率的损失,在数据处理中需要补偿地层吸收的能量。
  22. Honeycomb impact loading arm, accurate calculation of the absorbed energy is very difficult.
    蜂窝夹层摆臂受到冲击载荷作用,准确计算的吸收能量是很困难的。
  23. The maximal rectangle correction is introduced in the horizontal correction, also considering that the resist absorbed energy density distribution is different at different depth.
    水平方向采用最大矩形法校正,同时考虑了抗蚀剂不同深度处吸收能量密度分布不同。
  24. The relation between resist absorbed energy density distribution and dose is taken into account in vertical correction.
    深度方向的校正从吸收能量密度与曝光剂量的关系上考虑。
  25. Moreover, the impact of different exposure and development on resist absorbed energy density distribution, line width and side degree is investigated.
    在准确模拟曝光、显影过程的基础上,研究了不同曝光、显影条件对抗蚀剂吸收能量分布、显影线宽、边墙陡度的影响。
  26. But the dissipation in the elastic deformation energy of the whole structure is to obtain quantitative estimate of the absorbed energy first established in ballistic composite structures under impact loading, honeycomb sandwich panels under impact conditions moment mathematical model analysis.
    但是耗散于结构整体弹性变形的能量是可以获得定量估算的,首先建立了数学计算模型分析复合材料结构在弹道冲击载荷作用下,蜂窝夹层板的受到冲击的瞬间状况下的吸收能量。
  27. The tensile strength, failure strain, absorbed energy and resilient energy are all rate sensitive.
    拉伸强度、失效应变、能量吸收和能量回复都具有应变率敏感性。
  28. Simulate laser ablation of transparent dielectric material, get the results of distribution of the laser energy balance, absorbed energy distribution along the propagation direction of wave, the spatial distribution of energy absorption, changes in the maximum free electron density.
    对激光烧蚀透明电介质材料进行了数值模拟,得出激光的能量平衡分布、吸收的能量沿传播波方向的分布、吸收能量的空间分布、最大自由电子密度的变化。
  29. So higher electron beam voltage can reduce the proximity effect. ( 2) The effect of resist thickness on absorbed energy density distribution is not serious. It mainly affects forward electron scattering.
    因而,高入射电子束能量有利于邻近效应的降低。(2)抗蚀剂厚度对吸收能量密度分布的影响不是很明显,主要影响前散射电子的能量密度分布。